Automobile manufacturers. Originally called louvers cut holes in the engine of the motor to cool the engine. Louvers can be done with a sheet metal nibbling machines and then stop dead at the same louver forms and cut sheet metal as they press through it. Louver death consists of two halves, male and female mortality on the ground dead. Pressure die man dead women and their straight edge cut through metal. While the men made via metal extend to it and give it shape and flushes it away from the surface.
 |
| Louver |
Teaching and learning.
1. Set up a drill press to pause or press Louver Louver Insert .002 brass sample set. Adjust the height of the top of the press to allow maximum clearance between the punch and die cutting blade. Click below to knife fight male female to die in the press the bottom of the 1/16-inch to 1/8-inch male die Do not push all the way down it will be harmful to the cutting edge of the blade.
2. louver punch move forward until the cutting edge of the blade pierced the tasting room with brass
3. put under the sheet metal louver punch die Click below to drill test Louver check test Measure the depth of Adjust the depth of cut to cut all the way through until the sheet metal Re - test the new sheet of metal. Not fight again because the previous test strips may be damaged louver die
4. After you cut the first louver, Orient edges cut end of the louver to stand on the right side of the punch die Leg used as a guide to the louvers are spaced evenly to the sheet metal as they do. The second punch. To align the end edges of the louver to meet regularly with their legs out of the area where you go.
No comments:
Post a Comment