How to use sheet metal

How to Use a Sheet Metal Roll-Forming Machine
Sheet metal roll forming equipment used in a series of coils form a seam in the temple complex and light sheet metal flanges. Most machines roll forming to focus on the connection pipe fabricating and tubes for industrial HVAC correctly and operating machine roll forming in addition to how to turn the radio on it also to check daily, and. oiling and cleaning to ensure that roll smoothly when running in place and not metal, which can cause congestion. Injured

Roll forming Process

1. Your safety glasses.

2. Place a socket that matches the lock on the door when entering the 3/8-inch drive ratchet and loosen the nut holding the guard to the top of the roll forming machine.

3. When the lift up to remove it from the top of the original roll.

4. Blow out the area between the coil and air ducts to remove scrap metal and other debris from a series of rolls and spray rolls with oil to increase lubricity and corrosion protection from forming on the face of the roll.

5. Scroll back up to keep the studs and tighten the wheel nuts to secure the roll to protect the image.



6. Detect, prevent installation to ensure that as part of a protected area does not fall in the feed roll forming machine and start guide, located on the bed, entering in the face of the protection that is not damaged.

7. Turn formed by rolling discounted green start button.

8. The remaining side of the metal coil to be made to guide the start and metal slides on the guide.

9. Support plates, as captured by roll forming machine, how to work it down through a series of roll and ejected from the far side of the roll forming machine.

10. Check finished rolled edges to make sure the clearances are required if you notice that the joint is malformed or jammed tight, winding, adjusting manual operations and run a piece of sheet metal roll forming machine others.